NOTE: All Complete Control
remotes manufactured after November 1, 2006 (and all MX-3000s since April 2005)
are compatible with the MRF-350
MRF-350 Product Features
Improved Spurious Adjacent Signal Rejection:
The MRF-350 receives Narrow Band
RF (radio frequency) signals via the RFX-250 RF Sensor (antenna module).
The RFX-250 displays RF interference via a bright red LED which flickers when
interference is present. Simply relocate the RFX-250 out of the
interference area to resolve the problem.
Expand Range by Adding RFX-250
RF Sensors in Remote Areas
The MRF-350 can power up to three
RFX-250 RF Sensors connected in parallel to the RF Input connector.
Variable IR Output Matches Rear
Panel IR Inputs
The MRF-350 is equipped with
adjustable IR line outputs. Each output can be individually matched to
rear panel IR inputs on any component that is designed to be operated by a
standard IR repeater. The outputs utilize a 3.5 mm jack.
Control Six Identical
Components or Zones; Install Up to Fifteen MRF-350s in the Same Installation
The MRF-350 has six
“addressable” IR Line Outputs. For example, you can control up to six
identical TVs with one MRF-350 or route volume commands for a specific zone to a
particular zone IR input on a multi-zone pre-amp. If you have more than
six identical components or zones, up to 15 MRF-350s can be separately installed
to control them—thereby allowing up to 90 identical components or zones in one
house.
The MRF-350 is compatible with the
MX-3000, TX-1000, MX-950 and MX-900 (only). Each can be programmed to
specifically control components in a particular room by installing a base
station at each location. In operation, it’s simple: when you select a
device located in the Den, the remote only send commands to the Den. When
you select a device located in the Family Room, the remote only sends commands
to it.
IR Input for Multi-Zone Loop
Through, Keypads or IR Repeater Systems
The MRF-350’s rear panel IR
input will relay IR data from IR repeaters or multi-zone keypads to all IR line
outputs (does not support IR routing). The 5V, 100mA output will power
some keypads directly.
Specifications:
Power Supply: 9V
300mA
IR Flasher Line Outputs: 3.5mm
Mono Mini Jack
Compatible Remotes: All
Complete Control remotes manufactured after November 1, 2006 (and all MX-3000s
since April 2005)
RF Frequency: 418MHz
Size: 8.5"
x 3.875" x 1.375"
Compatible RF Sensors (Antennas): RFX-250
only
MRF-350 Package Includes: One
RFX-250 antenna, Six wired IR emitters (each 10' long)
